• +0086-371-86162511
  • Zhengzhou, China

replacement of sand by marble powder in concrete

Stay Touch
With Us
Get Quote

News & Detail

  • Experimental Study On Concrete Using Waste Marble powder

    of using marble powder waste as partial replacement of fine aggregate in concrete. Since this concrete is prepared with marble powder as a partial replacement of fine aggregate (Sand) in four different proportions i.e. 10%, 15 % ,20% and 25 % and tested for the period of 7days, 14 days and 28 days.

  • Study of Properties of Concrete using Marble Powder and

    [1] Nitisha Sharma studied the properties of Waste Marble Powder as a Partial Replacement in Cement Sand Mix This was done by replacing cement by a percentage of marble powder. Four basic concrete mixes were considered. When cement is replaced with marble powder up to 10% weight, high strength concrete was achieved.

  • Use of Waste Marble Powder as Partial Replacement in

    It can be observed that the flexure strength for the concrete mix containing 10% of marble powder dust in cement got increased by the value of 9.2% and for 10% replacement with sand the flexure strength also got increased about 9.3% but it decreased when the mix contains 20% marble powder dust against cement (10%) and sand(10%) about 10%.

  • [PDF] Study On Concrete Using Marble Powder Waste As

    Marble Waste (Marble sawing powder, and marble sludge or slurry) is a widespread byproduct of marble processing industries. All these wastes are thrown away in the areas near the factories and cause severe environmental problems. The main objective of this study is to explore the possibility of using marble powder waste as partial replacement of fine aggregate in concrete.

  • Partial Replacement of Cement With Marble Powder in

    The test results show that the compressive strength, split-tensile strength and flexural strengths are achieved up to 30% to 40% replacement of cement with marble powder without affecting the characteristic strength of M20(1:1.5:3) grade concrete. KEYWORDS: Cement (53 grade), Marble powder, Fine aggregate (M-sand), Coarse aggregate (20mm size).

  • Partial replacement of sand with marble waste and scoria

    This study aims to investigate normal strength concrete by partially replacing sand with marble waste and scoria. Experimental investigations were conducted to study the chemical, physical,...

  • “Experimental Investigation in Concrete by Partial

    after the research shows that marble powder can be used asa replacement for cement. From compressive strength tests it is concluded that the best proportion of marble powder is 10% with 28 days of curing. Use of marble powder in concrete does not affect the setting time of concrete

  • Partial Replacement of Fine Aggregates with Quarry Dust

    alternative to fine aggregate in concrete. In the present investigation workability and strength of concrete was evaluated by replacement of natural sand by Quarry dust and marble powder in equal proportions of 0%, 10%, 20%, 30%,40%,50% and 60% is studied for M25grade concrete cubes. Slump cone method is taken for finding

  • IJERT-Use of Waste Marble Powder as Partial

    The properties of a concrete mix if varying marble powder dust is main objective of this study is to develop useful concrete mixes partially replaced in the concrete mix. using waste marble powder as partial replacement of cement and sand. 1.1 Research Significance Keywords: Waste marble powder, concrete, compressive strength, flexure strength, split-tensile strength, workability, durability.

  • UTILIZATION OF WASTE QUARRY DUST AND MARBLE POWDER IN CONCRETE

    incorporating marble powder as partial sand substitute. Corinaldesi et al. (2010), found that at same workability, marble powder showed high strength at 10% sand substitution. This research aims at utilization of waste marble powder and quarry dust in concrete as partial replacement of sand.

  • “Experimental Investigation in Concrete by Partial

    after the research shows that marble powder can be used asa replacement for cement. From compressive strength tests it is concluded that the best proportion of marble powder is 10% with 28 days of curing. Use of marble powder in concrete does not affect the

  • [PDF] Study On Concrete Using Marble Powder Waste As

    Marble Waste (Marble sawing powder, and marble sludge or slurry) is a widespread byproduct of marble processing industries. All these wastes are thrown away in the areas near the factories and cause severe environmental problems. The main objective of this study is to explore the possibility of using marble powder waste as partial replacement of fine aggregate in concrete.

  • Partial replacement of sand with marble waste and scoria

    The seven variant concrete mixtures were made by partially replacing marble powder (up to 15%) in place of sand; cement and amalgam were evaluated for the mechanical strength, ultrasonic velocity...

  • An Experimental investigation on utilizations of Marble

    The durability as well as workability has increased to large extent by use of marble dust as replacement of fine aggregate and coarse aggregate. The effect on properties of concrete were investigated and concluded that optimum percentage for replacement of sand with marble powder in

  • Influence of Marble Powder Mortar and Concrete Mix

    Partial replacement of cement by varying percentage of marble powder reveals that increased waste marble powder (WMP) ratio result in increased workability and compressive strengths of the mortar and concrete. Er. Tanpreet Singh and Er. Anil Kumar Nanda, Associate Professor & Head Surya School of Engg. & Tech. Surya World, Rajpura Introduction

  • Cement Replacement in concrete with Marble Dust

    Cement Replacement in concrete with Marble Dust Powder. IRJET Journal. Download PDF. Download Full PDF Package. This paper. A short summary of this paper. 37 Full PDFs related to this paper. READ PAPER. Cement Replacement in concrete with Marble Dust Powder. Download.

  • What are the Materials for Replacement of Sand in

    Granulated blast furnace slag is a waste of steel industry; its use can be best exploited as part replacement of sand in concrete. It can replace sand to the amount of 70 % in concrete mixes. Its Availability is limited, restricted to steel plant area.

  • Characterization of marble powder for its use in mortar

    01-01-2010· Marble powder was used as a 10% replacement of either cement or sand, with or without an acrylic based superplasticizing admixture, which was added at a dosage of 0.5% by weight of cement. 6 . Preparation and curing of specimens

Quick response, N-CAI Heavy Industry welcomes all sectors of society to contact us, we are waiting for your inquiry within 365x24 hours!